The MULTI 6 controller series is available in practical 6-zone steps. Its modular design with independent slide-in controller slots ensures fast replacement in case of malfunction.
Perfect ease of use and a straightforward display showing all instantaneous and setpoint values guarantee the smooth integration of these controllers into the production processes.
The alarm indicators only light up in case of error or malfunction. This allows to check the operating state of the hot runner system at a glance.
Due to the presetting of the system’s basic parameters by the factory, time-consuming configuration is not necessary – the unit is immediately ready for use. The mold memory enables you to store the settings for all of the hot runner molds and access these programs by a touch of the button.
A solid metal housing with powerful cooling fans allows continuous operation at maximum load even under extreme operating conditions. The rear panel features separate connectors for the load and thermocouples, the power switch, interface and alarm connectors.
The temperature can be increased or decreased externally by the alarm cable connecting the controller to the control system of the machine. In case of malfunction, the controller stops the machine immediately.
Metal enclosure, powder-coated
Available units / Order information
36-slots / TS.MULTI 36
Mold connection (load and TC separate)
Connectors x number of poles
36-zones 3 x 24-poles / 3 x 32-poles (TC)
Power supply (+/- 10 %, 50 - 60 Hz)
Voltage / Connector / Connected load
400 VAC / 32 A CEKON / 22 kW
Power output:max 16 A per zone, contactless
Thermocouple: Fe-CuNi type J or L
Control precision: Better 1 °C, self-optimizing
(if hot runner permits)
Control range: 50 - 500 °C (122 - 932 °F)
Operating temperature: 10 - 40 °C (50 - 104 °F)
Alarm outputs: 2 changeover contacts
Control inputs: 2 switch inputs (contacts)
Data interface: for SUB-D plug 9-pole
Setpoint and instantaneous values for all zones (°C or °F),
power output in amperes or percent, alarm indicators for
temperature (over- or low temperature), current (overcurrent,
open load), TC malfunction (open, reverse)
Soft-start programmable, compound heating, sensor monitoring,
power measurement; manual control mode, temperature
reduction (standby), temperature increase (boost), mold memory,
parameters programmable, data interface, cascaded operation
(combining several controllers into a single system)